Products
CLINGA FLEXI-ARMS NOW AVAILABLE IN 6" AND NEW 3" MODELS |
|
| The wait is finally over! A lightweight arm that can be adjusted to give you a fully flexible indicator to a stiff arm and anywhere in between. Specially designed hard wearing rubber connectors with a strong but lightweight arm allow you to fish totally slack lines with the added benefit a stable indicator should the wind blow. |  |
FLEXI-ARMS |
|
|
Here you can see the versatillity of the Clinga Flexi-Arms. The near indicator has the arm in its fully hinged position. The far indicator is at it's locked position. In this position there is still plenty of flexablity in the rubbers so that the slightest of touches can be seen. |
 |
RECOMENDED CLIPPING |
|
|
We found that by pulling the line into the ball clip position on our Kippa Clip (as shown above) resulted in the best indication. To set up the Flexi-Arm is so simple. Screw your chosen head onto the threaded adaptor until it meets the rubber upstand and the Kippa Clip is in the correct position (check out the pictures). Next push the other end onto your Clinga Link until it stops or with the use of a Clinga Conversion Kit screw into your chosen hockey stick. Now this is where the Flexi-Arm comes into it's own...by moving the arm towards the Clinga Link or hockey stick the Flexi-Arm will "stiffen up" almost at a set position which is perfect for slack line fishing as there is almost no weight pulling down on your line. There is of course plenty of "give" to allow for perfect indication when you get a bite or a take. Conversly, if you leave the arm in the position it's in straight out of the packet then it will act like a traditional "butt banger" arm allowing free movement up and down. You have the control to choose anywhere in between these two "extremes" just by simply moving the arm in or out to suit either your style of fishing, any given change of tactics or both....it's up to you!! |
 |
CLINGA DUMPY HEADS |
|
|
A new sexy head that fills the gap between the ultra cult Clinga Old Skool and the Clinga Standard heads. The same height as an Old Skool and but the width of a Standard...22mm x 15mm. Available in the same colours as all the heads...Red, Yellow, Green, Blue, Clear, Black and White PTFE. 5g in weight for all but the White PTFE which come in at 7g. These heads take a 4mm x 10mm Isolite which is the same as the Old Skool, so now you can just change the head for added weight and keep your favorite size Isolite. As standard the heads come complete with our legendary Kippa Clip. |
 |
